Junk Catcher – Internal Fishneck


To reduce debris on top of sub surface tools.


BT Junk Catchers are made up of 2 components:

1. Fishneck2. End Cap


Tighten end cap onto fishneck and attach to GS running / pulling tool and hoist inside of lubricator. Lower into wellbore to top of sub surface tool, jar down to shear GS. Remove toolstring from wellbore.


If a large amount of debris is expected, an extension barrel may be added to accommodate added volume. Ensure that jarring down to release the junk catcher will not damage equipment below.

Download Technical Datasheet

Junk Catcher - Internal Fishneck